Hi,
I've already been using the Calc VET method for a few logs but wanted to check the IFR (B4001) before continuing. I'm using a Holden/GTO 04 LS1 in an RX7.
The injectors I'm using
Bosch: 00 280 155 931
28.55 lbs/hr @ 43.5 PSI
They appear to be the same as the Z06 LS6 injectors so I copied over the IFR table from a standard Z06 tune (02 LS6). However when I did some more reading and found the Bosch injector ratings they are rated 28.55 lbs/hr at 43.5 PSI and not the 58 PSI FPR pressure I'm using (un-reference Corvette FPR). So when I used the injector spread sheet on this site the figures for B4001 came out larger obviously (+13%).
So I'm now unsure if I should use the Corvette IFR values or the corrected figures assuming the injectors are rated @ 43.5 PSI. I've attached the log of my car driving home after 3 corrections using Calc VET. Not the best but it was hard to any sort of open run.