AutoVE filter
I recently discovered a great additional filter for logs when doing AutoVE.
Log Fuel Trim Cell Number, if you exlude values 16 and above which are for idle, deceleration, dfco and other ??? conditions, leaving just on the gas values.
BEN values become very stable, I also filter engine temp <85 and >95, LC-1 sensor state values not = 1 and ETCTP CHANGING > 5%.
Sensor status values
0 "Unknown" "Unknown - possibly not connected"
1 "Lambda" "Valid Lambda and AFR data"
2 "%O2" "Free air detected"
3 "Cal" "Calibration in progress"
4 "NoCal" "Calibration required"
5 "Warmup" "Warming up"
6 "HCal" "Heater Calibration"
7 "Error" "Error"
Reply With Quote