7.4L- 0411ecm - WAY! TOO RICH AT CRANKING

[stroker97k1500]

To give a little background on my setup, it is a 2000 model 454 with a 0411 ecm put in a 97k1500 truck with a custom wiring harness ect. The ve table was corrected with auto-ve with efilive and the spark table is so so... but don't have any spk retard.... the injector tables have been corrected, cylinder volume as well,and also the maf is set to fail and "non emissions" hoping to avoid the MAF from being "not" calibrated perfectly. I used a spread sheet to get my cranking ve table in line but the table B3604 has been played with by me A LOT as well as other parameters like throttle cracker,

The problem I have is that it will not start (is too rich)without pushing the throttle all the way to the floor while cranking to clear the flood....but once it is running it runs just fine. I have played with every crank/start parameter I could find but have not gotten anywhere. Any opinions or suggestions would be greatly appreciated to help with pointing me in the right direction of how to correct this issue.
Thanks,
Robby

ps my tune is attached