Here is a log I took last night, with a bit of hard driving.

Wherever there is burst knock, my knock sensors do pick up some knock, so this means I should leave the burst knock setting as its not pulling out timing in situations of no knock?

As you can see there is a bit of knock going on and my scalar goes up to 50%, how would you go about fixing this.

For example: Frame 4155, there is large knock occouring, would I just go to my high spark map and pull out a degree of timing in that single cell and log again? or do you pull out the same amount of timing as kr pid does, which would be 7 degrees in this case? Do you then smooth the cells around it?

Dialing in AFRs was pretty easy to do, but spark is a bit harder.

E38_0020.efi