I've been trying the Calc.VE tutorial, set everything up ...apparently wrong.

Followed this thread a bit

http://forum.efilive.com/showthread....etting-started

Using weathermanshawn's calc_pids.txt(thanks)

I have a AEM Uego W02 hooked up to the V2 w/ a serial cable.

Went for a short drive just to make sure I set things up right, my maps don't look right, and I can't figure out why




I already changed the precision to 4


Setup wise its a '98 suburban k1500 with an 0411 swap, stock 5.7 (so far)


any direction is greatly appreciated.



thanks!