Results 1 to 7 of 7

Thread: MAF and IAT calibration

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. November 1st, 2010 #1
    68problemchild
    68problemchild is offline
    Lifetime Member 68problemchild's Avatar
    Join Date
    Mar 2010
    Posts
    315

    Default MAF and IAT calibration

    Hey guys. I have a custom setup. Why is it when I put stock parameters in for my maf, my IAT goes way out of whack at key before start?

    If you find a stock maf in a known tune, can you be assured the table is correct? If not, is there a way to calibrate it?

    Thanks!!
    Last edited by 68problemchild; November 1st, 2010 at 01:43 PM.
    http://www.flickr.com/photos/41575483@N07/
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. MAF Calibration..Why not use SAE MAF vs CYLAIR DMA
    By WeathermanShawn in forum Gen III V8 Specific
    Replies: 10
    Last Post: September 30th, 2008, 10:44 PM
  2. IAT Sensor when MAF bypassed
    By Robbie The Wrench in forum Gen III V8 Specific
    Replies: 9
    Last Post: August 16th, 2008, 08:33 AM
  3. 5 Wire MAF IAT
    By shakinlm7 in forum General (Petrol, Gas, Ethanol)
    Replies: 6
    Last Post: October 2nd, 2007, 03:20 AM
  4. How Do I Enable IAT with MAF Disabled?
    By Chalky in forum General (Petrol, Gas, Ethanol)
    Replies: 8
    Last Post: May 14th, 2006, 07:34 AM
  5. Open Loop with Electronic Throttle and IAT in MAF
    By deezel in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: November 18th, 2005, 06:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules