Can anyone point me in the right direction, i have an autometer wideband in my car and wish to log with bbx.

I have setup what I think is the correct calc.pid for my analogue output but after reading some posts i am not sure. I will more than likely not be using this for autove but just for logging when doing some hard runs or 1/4 times. attached is the file, is this correct? and if i need to write another calc.pid do I add to this file or create another file.
The gauge has a 0-4v output with 0v=10.0 afr and 4v=16.0afr

calc_pids.txt

I can see the pid in the scan tool but cannot find the pid in bbx software, what do i do to add the pid to the logging software and upload it to flashscan

Thanks