I hope I posted this in the correct place. I could use some help please, I can
not for the life of me get my DSP5 switch to work. I installed the switch and
then did a full flash of my DSP5 tune. I wanted to check the DSP5 switch to make
sure it's working so I hooked up the V2 and ran the scan tool and checked the
PIDs. The DSP switch voltage is at 4.98 volts and the DSP Tunes reads NonDSP.
Neither the voltage changes nor does the NonDSP change when I move the DSP5
switch from one position to another.

I know I have the red wire in the ECM connector in the correct place (I took a picture of where I installed it at and had it verified by somebody that knows a lot more than me about this) and to
remove the black wire out of the equation I ran it to the firewall and grounded
it there. I've pulled the ECM connector out several times making sure the red
wire was seated in all the way, I even used a paperclip to make sure it was
seated down into the connector. I know the LMM switch pins on the switch wires
are "keyed" and go into the connector one way and I've installed them in the
correct way.

The V2 is up to date as far as updates goes. I Ohmed the switch and the Ohms
read:
27K
5.6k
2.2k
1k
270

I did a continuity check of the switch at the black wire to ground and the black
wire is grounded. I've even pulled the ECM connector off the ECM and then stuck
two sewing machine needles inside the ECM connector one on one side one on the
other where the red wire goes into the connector and did a continuity check and
that checked out ok.

When I ran the switch install and every time I've messed
with anything concerning the switch I've always unhooked both batterys.
My DSP5 tune was made by a very well know person in the EFILive business but he's
not been any help helping me figure this mess out. I've spent hours trying to
figure this out on my own, I'm frustrated and not a happy camper and feel I've
wasted good money on something that's not working. Sorry this has been so long
winded and I would appreciate any help. Thanks.