Well I'm learning.....I've got my efilive up and running on my turbo Silverado and I'm at the stage of autove ...
Autove is setup with my v2 and a Aem ungo wideband (I'm using plx pids.they are close) and here's my question...
I made a 35 minute log and covered a lot of cells....painstakingly covered allot of rpm/kpa....this particular log I saved while is was watching cell count before I averaged the cell count....I went back and opened the log, seen it was on cell count , switched to average cell count and now l the cells shows 10.7 to 10.8 rather than all the 0.7-2.1's I observed during the drive.....can I recover the log somehow?