I have a 2013 Camaro ZL1 and purchased a 650hp upgrade kit from Lingenfelter.
This included an Autocal and tune. I followed the instructions, read my stock tune to the Autocal, and flashed the supplied tune. Now the car will not start.
It is a manual and the DIC says depress clutch to start. When I depress the clutch it makes no difference. I was no where near the gearbox when installing the upgrade kit, nor was I under the dash at all.
I looked at all the PID's and there is one called CPPV which I am guessing is clutch pedal position voltage. It reads zero regardless of where the clutch pedal is located, depressed or not. I am guessing the car does not know that I have the clutch pedal depressed.
I have tried to contact LPE but no luck yet. I am located in Australia so have VERY LIMITED SUPPORT here so am relying on remote support.
Please help, I have an expensive car that's a boat anchor at the moment.
Thanks,
Terry