Results 1 to 10 of 18

Thread: Car loses some functions because when V2 is connected

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. January 24th, 2016 #11
    Blacky
    Blacky is offline
    EFILive Developer Site Admin Blacky's Avatar
    Join Date
    Mar 2003
    Posts
    9,608

    Default

    I have identified a potential config setup in the FlashScan firmware that may be responsible for interference on the low speed CAN bus. Please use EFILive_Explorer to program in the attached firmware update into your FlashScan. This update has the same version number as the latest release (V2.07.95) so that you can swap between this firmware and the release firmware. The date on this firmware is Jan 25, 2016 so you can tell it apart from the release firmware.

    Regards
    Paul
    Attached Files Attached Files
    Before asking for help, please read this.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Full flash only loses serial number
    By roughneck427 in forum Duramax LB7
    Replies: 7
    Last Post: July 16th, 2013, 12:23 PM
  2. DSP5 installed and ECM loses communication
    By dansdieselp in forum Duramax LB7
    Replies: 5
    Last Post: August 7th, 2012, 01:48 PM
  3. RR Loses VIN and CASE and OLM after losing power?
    By N0DIH in forum RoadRunner Real-Time PCM Emulator
    Replies: 14
    Last Post: February 1st, 2011, 03:44 PM
  4. roadrunner loses comm. and locks up software
    By rubbersidedown in forum RoadRunner Real-Time PCM Emulator
    Replies: 2
    Last Post: September 20th, 2007, 01:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules