I got RR installed Sunday and actually managed to update my VE table while driving after talking to Craig Moates.

I went out today and tried to double check my work by updating my VE in RT and my VE table starting going crazy. My idle cell is 45KPA x 800 RPM and is 39.6 currently. RR in RT started driving this cell up to 60+ before I stopped the update. It was not a good update as car just barely ran.

Anyway, I have everything set up for KPA and am using same settings from VE table to configure BEN Map. BEN Map was showing nor more than a 1.20 correction factor.

Also, having issues with verification in RR. Keep getting the following message: calibration contains one or more incorrect segment checksum.

Craig suggested doing hard reset but not sure if I am doing it right. Not even sure what I accomplish by doing this.