Results 1 to 10 of 11

Thread: V2 Stuck in dead poll

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. November 26th, 2007 #1
    minytrker
    minytrker is offline
    Lifetime Member minytrker's Avatar
    Join Date
    Jan 2006
    Posts
    1,332

    Default V2 Stuck in dead poll

    It was not like this last night after the update. Now today after the update for BBL my v2 box is flashing lights likes it is in dead poll mode but its not. I never plugged into a car yesterday just my laptop. No matter what I do the box stays flashing like in dead poll mode. If you try to acess it in dead poll mode it says hoold down control even though you are. It wont read a car or connect to my laptop. Just plugging it into a car it will flash the dead poll lights with the ignition still off.

    I need help ASAP! I have a customers car here that I have to have done by tomorrow morning.
    Last edited by minytrker; November 26th, 2007 at 04:28 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. This is total BS - stuck in dead poll mode.
    By Mr. P. in forum FlashScan V2
    Replies: 5
    Last Post: September 9th, 2009, 09:35 AM
  2. stuck in dead poll mode
    By stacks04 in forum FlashScan V2 BB Logging
    Replies: 6
    Last Post: June 26th, 2008, 03:52 AM
  3. Dead Poll
    By sfcjones in forum Black Box Logging
    Replies: 4
    Last Post: March 26th, 2008, 01:10 PM
  4. FS not communicating in dead poll
    By Big Block in forum Black Box Logging
    Replies: 4
    Last Post: January 7th, 2008, 12:24 PM
  5. PCM in Dead Poll State?
    By vetteboy2k in forum General (Petrol, Gas, Ethanol)
    Replies: 4
    Last Post: October 6th, 2005, 11:19 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules