Hi all,

I have a problem with my Flashscan.
When I record a session some data doesn't change its value.
For example the ltft 1 works fine and the ltft 2 stays at 58%. The same with the vehicle speed. It stays constant at 58 km/h. The TPS is constant at 23% and so on.
RPM, Airflow, LTFT1, Intake temp, ECT work just fine.
The car also doesn't seem to have any drivability issues.

One thing I have noticed is, when I clear all values and start the engine it will show correct values for a few seconds and then will jump to the fixed valued and stays there.

I always check all PIDs before I log but lately the MAP sensor won't respond and will act as if its not there.

Is there any way to reset all sensors?

BTW. I use COS3 in a LS1

Please help me,
Thanks,
Alex