Results 1 to 10 of 49

Thread: 2000 to 2002 cos5 auto VE problem

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Member RandyWS6's Avatar
    Join Date
    Jan 2005
    Posts
    115

    Default 2000 to 2002 cos5 auto VE problem Vilent bucking

    Ive been doing some logging and have a problem with vilent bucking from off idle (But idles fine) but when i pull out and up to 2400 rpm it bucks vilently ,this is a M6 car, But above 2500 rpm it runs fine, but i can put my 2000 tune back in and run fine threw all rpms. can some body look at my log and COS5 tune and see if there is any thing wrong in the low rpm range. if i could get rid of the bucking i could get my auto ve tune done. In the log you can see the WB oscillating from 12.0 to 19.0 ,it bucks so hard it jerks my foot off the throttle. Here is a snap shot of the log were it shows the bucking ,this pic is fron the same tune that i have posted up here.
    Attached Files Attached Files
    Last edited by RandyWS6; March 27th, 2008 at 04:37 PM.
    2000 WS6 TransAm-M6 LS3 forged 422 cid. 4L80 FMVB ,4:22 Ford 9"-35 spline axles
    2014 C7 3LT-Z51 Corvette Stingray M7 , A&A Supercharger , Kooks 1-7/8" long tubes & X Pipe 615 rwhp & 560 rwtq


    http://community.webshots.com/album/259987907DcztOG

Similar Threads

  1. upgrade from 2000 o.s to 2002.os
    By smslyguy in forum Vortec V6/V8 Specific
    Replies: 2
    Last Post: August 31st, 2009, 06:18 AM
  2. Anyone done a Corvette 2000 OS to 2002 OS change?
    By aleco99 in forum Gen III V8 Specific
    Replies: 5
    Last Post: September 24th, 2007, 01:24 AM
  3. Does any body have a OS 2000 to 2002
    By RandyWS6 in forum Gen III V8 Specific
    Replies: 6
    Last Post: August 21st, 2007, 08:40 AM
  4. Going from 2000 to 2002 OS problem ?
    By RandyWS6 in forum Gen III V8 Specific
    Replies: 30
    Last Post: June 9th, 2007, 10:00 AM
  5. ? ON CUSTOM O.S. & 2000-2002 FLASH
    By nitrorocket in forum General (Petrol, Gas, Ethanol)
    Replies: 7
    Last Post: September 6th, 2005, 02:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •