I'm pretty sure that was fixed in the latest release V2.05.18 - which is being posted tonight on the main website download page.Originally Posted by oztracktuning
Try this: after logging (I presume pass-through to the laptop), and after disconnecting the scan tool, press the Ctrl+Ok button. That should re-detect the ECM/TCM combo.
What happens during pass-through is that the PC sets FlashScan to only "know" about one module, the ECM or TCM - depending on what controller you select when the Scan tool connects. That is a limitation of the V7 software, V8 software will connect to multiple controllers at once. You can see the change in the lower right corner. It changes from CAN 02 to CAN 01 when you connect via the PC. You have to change it back to CAN 02 by pressing Ctrl_Ok.
In the V2.05.18 firmware, it does that automatically when pass-through logging is disconnected.
P.S. Just in case you did not know, to reboot FlashScan you can press Ctrl+Cancel.
Regards
Paul
Reply With Quote