Quote Originally Posted by Blacky View Post
Check the factor and offset used to calibrate the A/D voltages.
You can check using EFILive_Hapi on the "F5: Calibrate A/D" page. Click on [Get Factor/Offset] to see what they are set to.
If you click [Display data] you will see the raw A/D counts and the calibrated voltage.

Don't click [Initialize] or [Calibrate] unless you really mean to supply the appropriate voltages and actually calibrate the sensors.

Regards
Paul
No factor offsets are shown and no voltage for any AD now.
Also recording with scan.exe AD1 and AD2 shows no voltage.
In the self tests of V2 I see AD counts for AD2 now but external sensor
data shows nothing for AD1 and AD2.
Basically AD2 works but now voltage is not being displayed for
any of the ADs through V2 directly or passthru.