Howdy all,
I have a Vortec 350 in my Nissan Patrol Winch Challenge race 4wd here in Australia.
I dont have the standard ECU/PCM controlling the engine, I have a Microtech LT-8 hooked up to it.
I have a few questions in regard's to the crank angle sensor and the triggering system for the ignition.
It has a 3 wire plug to the Crank Angle Sensor, they are Orange ( or faded red) Purple and Yellow and the water seal is purple.
What one of these wire's is the + (Pos) which one is the - ( Neg) and which one is the signal wire?
Also is the trigger from the Crank Angle Sensor + or -
The reluctor is a 4 blade style one, and the ECU has been set-up to suit a hall effect style ignition, is this going to work? If not what style does the standard ECU/PCM run?
Thank's for any help you can give me as there is bugger all info down here on this engine!
Cheer's all,
Steve.