LC-1 widband hook up

[W_D_R]

Just recieved my new lc-1 from innovate. Old one quit, sent it to them for repair and got a new one in the mail at no charge. Here are some pics before a put it in the truck seem correct to yall?

I soldered the green blue white and one side of the monetary switch together. ground.

I need to add another wire from my ground above to the V2.

I soldered the other side of the led and momentary switch to the small black wire.

red will go to power.

yellow to V2.

brown to nothing.





Wes

[joecar]

Does it work when you power it up...?

[W_D_R]

I have not powered it up.

[joecar]

I do a bench test (connect to power) before installing, make sure LED indicates correct operation... blow on sensor (or run propane torch on it) and note change in reported AFR.

[W_D_R]

Installed lc1 today. Went through the new install procedures, everything seems to work ok except I still have my original problem.

log works reads ~14.6
efi live reads ~20.5



Wes

[mr.prick]

Are you using serial or analog connection?
Have you selected the proper PIDs?

[W_D_R]

I am using the autove pid selection.

I believe its analog. From the 2.5mm out jack on the lc1 I have a 2.5mm to something adapter, then a something adapter to usb. and I have the yellow wire to A1+ and ground to A1-

[mr.prick]

Did you program the analog output and select the fuel type in Logworks?
The yellow wire is not pre-programmed to match the analog PID for the LC-1,
the brown wire is.

[W_D_R]

I did program for log works.
I will go switch the yellow for brown and report back in a moment.

[W_D_R]

Swapped yellow for brown, still did not read the same but it was closer. Would a taq cable benefit me?