i was wondering if there would ever be an option to add another table to control a second stage in COS5. Im sure im not the only one who would like to see this happen.![]()
i was wondering if there would ever be an option to add another table to control a second stage in COS5. Im sure im not the only one who would like to see this happen.![]()
No, LS1 custom OS's will not likely be enhanced from what they are.
I no longer monitor the forum, please either post your question or create a support ticket.
You could do it by intercepting the IAT sensor with the second stage. Second stage would open the IAT circuit giving you an IAT of -39degC. Then timing modifications could be done in B5911 & B5943, & fuelling in A0014. It would not give a lot of adjustability but some reasonable control. If you were only running the first stage for a small area of the rev range you could reverse this & run the iat intercept for the first stage, & the nitrous pin & tables for the second.
The Tremor at AIR