Hello there everyone, Merry christmas and Happy new year to you all.
Well I am totaly new to this site and have only just found out about this software/tool.
I have a few questions and hope someone can give me the right answers to them, here goes.
1: I am building a Cobra replica useing a Gen III engine and T56 gearbox (commodore) the engine is from a 2001 vehicle and engine number is stamped as such, I have a VX commodore ecu (approx 2001-2002) I have a factory wireing harness and dont want to fit a BCM so I need the VATS bypassed (I have been told this tool can do this ok) yes or no?
2: What do I need to purchase to do this at home? ie software, laptop, cables or anything else that may be needed?
3: How user friendly is this tool?
4: Can this tool be used to carry out a mafless tune?
5: How much will it all cost to setup for home use, I have access to a dyno if required.
Thanks for all and any help.