If you're going to do AutoVE, set the stoich AFR cells in B3647 to slightly non-stoich AFR... otherwise the stoich cells will enable STFT trimming on those cells.
If you're going to do AutoVE, set the stoich AFR cells in B3647 to slightly non-stoich AFR... otherwise the stoich cells will enable STFT trimming on those cells.
Also, set A0012, A0013 to some in-range value.
Also, unrelated, Set D0961, D0962 to 100%.
ok, how about this...and thanks for the needed update,,,
now for the second pass,,,
i will post a log of the new tune 3 soon
i will add this,
one problem, it wont start very good(had this from the start when installed this cam),is there a tune to correct the starting issue?
thanks
Something's going wrong, the injector duty cycle is going above 100% by a significant amount, and you're getting sawtooth pattern KR indicating real knock... I don't see the wideband AFR in your log.
From your previous post, the wideband measured AFR was way rich, again indicating something's not right...
Post some more logs in OLSD showing wideband AFR and BEN, and the tune file from which the log file came from.
i don't know what happened here but i will try to correct this for the next log