Hi all,
I have come across an issue with EFILive and my LM1 after I switched to a new laptop.
I am getting a very stable and consistent voltage signal from my LM1 through the cable (3.5mm jack) into my V1 interface.
When I turn on the Flashscan I get a very erratic and unstable voltage on the screen that swings widely (+/- 1.5+ volts)

Since I have changed computers and with my old laptop I can't recall having these issues I was wondering what is going on.
Are there any settings that I might have missed in EFILive that control these swings?
Currently I have all three cables (red, white,ground) connected in the orange connector that goest into the interface. Since I get a good and stable voltage from the I would suspect that the issue lies somewhere else.
I also log AD1 and AD2 but both are swinging the same.

I need to do some AutoVE but can't do so until I get the AFR readings right.

Thanks
Alex