After latest update ive lost all wideband and calc. pids I use for auto ve tuning. Can someone help me through this? Thanks in advance.
Chris
After latest update ive lost all wideband and calc. pids I use for auto ve tuning. Can someone help me through this? Thanks in advance.
Chris
Hi Chris,
Use the Scan&Tune (S&T) software (comes with V8 install), see attached... click Program to program it to your V2.
Thanks so much for the help. Awsome software and support!
I did as shown above and also updated firmware and boot block. Still when I connect to vehicle all wideband, analog and serial as well as ben's dont show up as supported pids for this 00 transam. Im guessing its a problem with calc pids? V2 is set to proper lc1 serial wideband. Any help would be appreciated.
Are you Black Box Logging or pass-thru (using the Scan Tool)?
Andrew
EFILive Crew
Im using the scan tool with laptop on dyno to tune and data log.
It's okay if they are not valid.
Select them anyways, once you start logging they will become valid and data will be visible.
This happens sometimes with passthru.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Even if I select wideband pid i cant seem to find my ben pids.
There were a couple of Serial PIDs actually shown in the WBO2-Analogue section incorrectly that was corrected in the last update. So, perhaps they have just moved?
Andrew
EFILive Crew
Were these PIDs made by you or EFILive?
Is it possible the calc_pids.txt was written over after a new install/update?
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________