E37 issue,

[Tordne]

Yeah I can see that, but that's not (for whatever reason) what the debug shows me :/ Did you get the email about remote access?

[madmatt]

yeah but I wasn't sure when a good time was to do this. do i need to be hooked to the truck for any reason?? it's late but i dont mind letting you look around in here.
thanks.

[Tordne]

Now is good for me if it works for you. Being connected to truck would be good so we can hopefully make some progress.

[madmatt]

ok, i'll download the software and see if i can set it up and i'll msg back.

[madmatt]

ok, the invite was sent

[madmatt]

thanks andrew,, disconnected before i could type that .

[madmatt]

ok so I've not worked out the E37 issue yet but thats not that important at the moment. I've developed a new issue since I've removed and installed and completed all the updates.
Now when building a DSP5 tune, after I've upgraded the os, converted to imperial, ran the dsp5 late LB7 imperial script, about half way through running, I get an "invalid floating point operation" error.

What's this??
thanks!!

[joecar]

Which software build version...?

[madmatt]

the latest. andrew got on my pc to verify in an attempt to figure out my earlier issue.

[joecar]

ok, cool