See this, from 2008 Z06.
Which year/model/vehicle manual do you have...?
Here is the connector views for 2008 Z06... look for the ECM views.
[ holy cow that car is very busy ]
The car was built in 2007.
Customs loom as a good chunk of the stuff is missing eg air-con etc.....
Do you want me to pull up the connector end views for a 2007 Z06 (they might be the same)...?
Many thanks for the documents - It all seems to match up.
CPP = Clutch Pedal Position = pin26 of E38-Connector X1
Wasn't expecting it to a a pot.
So the final question will be....
i) is it level sensitive
ii) is it -ve edge sensitive
iii) is it +ve edge sensitive
iv) is it edge sensitive (-ve or +ve)
Angus
Yeah, I thought it strange that the switch is a pot; it's probably level sensitive with hysteresis.
Where to buy the terminals for the E38 connectors ?
How to clone an entire ECM ?
We have a spare E38, and want to make a full (OS+Data+everything) copy to the spare.
Hi
Would you guess the pin26 input is active low or high ? Would the threshold be 2.5v ?
CalEditor@pcmcalibrators.com He can clone your ecm EXACTLY. Sharp guy.
1997 S10, 06 trailblazer SS LS2 swap, 4L70E trans, 76mm turbo. Factory ZQ8 suspension. 3.08, G80 w/a zexel. With a 0411 swap.