Converter Locking @ WOT, why

[JoshH]

I put a switch in last night. While it works, I would much rather have the consistency of the TCM controlling it. Was there a problem found that prevented the release of these tables? If not, I would really really appreciate if we could get access to them. Thanks.

[Shupe]

Subscribed

[Shupe]

Yes, I plan on adding these in for all the T42 OS's pretty soon.

Any idea if the additional tables for WOT lockup have been applied to all the T42 OS's yet?

[GMPX]

I had to go back and remind myself what they are, it was over a year ago we looked at this . I must admit once Rhino79 got sorted out it was put on the back burner and forgotten about.
Now that we again have an auto updating/patch system in place for the software, small updates like this are easier.
I'll add it to the to do list for all the T42 OS's (that have the tables anyway). ETA could be a week or a few weeks, it's only 6 parameters so it's not too bad, just that there is 25 x T42 OS's to apply it to.

[Laychut]

I put a switch in last night. While it works, I would much rather have the consistency of the TCM controlling it. Was there a problem found that prevented the release of these tables? If not, I would really really appreciate if we could get access to them. Thanks.

Hi JoshH,
Are you able to post a schematic or the pinouts you used to hook up the switch for the Lock up?

Cheers,
Laychut

[joecar]

I had to go back and remind myself what they are, it was over a year ago we looked at this . I must admit once Rhino79 got sorted out it was put on the back burner and forgotten about.
Now that we again have an auto updating/patch system in place for the software, small updates like this are easier.
I'll add it to the to do list for all the T42 OS's (that have the tables anyway). ETA could be a week or a few weeks, it's only 6 parameters so it's not too bad, just that there is 25 x T42 OS's to apply it to.

Hi Ross,
Can those WOT TCC tables be added to the LS1B OS's, like 12212156 and 12202088...?

[GMPX]

Assuming they exist, but it's been over three years now since I've looked at an LS1 PCM, I'll have to spend half a day remembering how to read 68332 assembly again.

[schwoch1]

Hi Ross,
Can those WOT TCC tables be added to the LS1B OS's, like 12212156 and 12202088...?

X2.... I know these are prehistoric PCM's by todays standards, but those tables would be of great help!!!

Mike

[Low03noma]

I had to go back and remind myself what they are, it was over a year ago we looked at this . I must admit once Rhino79 got sorted out it was put on the back burner and forgotten about.
Now that we again have an auto updating/patch system in place for the software, small updates like this are easier.
I'll add it to the to do list for all the T42 OS's (that have the tables anyway). ETA could be a week or a few weeks, it's only 6 parameters so it's not too bad, just that there is 25 x T42 OS's to apply it to.

You are my Hero!

[ScarabEpic22]

Sounds good to me! BTW did you ever find out what table(s) control the truck vs car OS in regards to keeping the TCC locked at 0% TPS? Im running a weird combo of ECM and TCM OSs (none are MY 08 tunes) and it works, but Id rather run the stock 08 ECM and TCM tunes if there's a table/param that could be adjusted. Not sure if its even possible, think the conclusion on the LS1B stuff was that it wasnt and to use a car OS.