got a 06 5.9 wont go past 120mm or past 6-8* timing i cant figure it out ? any hints tables i may have missed? scan tool showed it was stopping anywere from 115-123mm truck has a built 48re and exhaust any help is appreciated
got a 06 5.9 wont go past 120mm or past 6-8* timing i cant figure it out ? any hints tables i may have missed? scan tool showed it was stopping anywere from 115-123mm truck has a built 48re and exhaust any help is appreciated
Under limiters...go through all the tables and max them out, drive it and see if that changes your issue.
If so then do most of your limiting in the torque and boost tables.
maxing the tq table makes the truck shift stupid but i can try the rest
it made it shuttle shift 1-2 i had the tq tables pretty high in lower rpms ect and soon as i rescaled it that went away trans is like 1800 miles old
Sounds like you'll need to adjust your TTVA tables to solve the shuttle shift.
Adjust the lower values up a few % at a time till the SS is cleared.