LM-1 Interface Need Help

[MN C5]

Ok, I've got my LM-1 set to

.5 Volt -----equals 10 AFR

Set 4.5 Volts --equals 18 AFR (is there a way to check the settings without a cable?)

My wife cleaned out the garage a couple of weeks ago and I'm not able to locate my LM-1 cable or software. Being that I now have a new laptop I'm stuck.

How do I go about creating a calc_pids.txt for this. Or has someone done it so I can just copy and paste? I did it once but it was awhile ago.

I tried using the Tech Edge which has the correct formula of

AFR= {EXT.AD2)*2+9 but my LM-1 is reading a 10.2 AFR and EFI is reporting a 15.5 AFR. Could it be that after sitting for many months my battery in the LM-1 lost its charge and the settings I had in it?

Any help would be appreciated.

Dennis

[Ira]

You can get the software and updated firmware from the Innovate web site, www.innovatemotorsports.com. Or directly to the download page:

http://www.innovatemotorsports.com/support/download.php

Ira

[Black02SS]

I would use this. I have found on the LM1 that the output of .5 and 4.5 is actually .498 and 4.498. This formula is assuming that you have no ground offset issues.AFR = 1.995 * v + 9.00649

[ZL1Killa]

i use the lm-1 and use 1v=12AFR and 3v=16AFR and use the PLX pids...works great for me..at least for tuning N/A