Going from the stock 90mm TB to a NW 102 TB?

[PRAY]

Are there any tables I need to change in the E38 when going up to the 102mm TB's? I know on the older computers you had to change the ETC throttle area conversion table. Do the E38's have a similar table? If so, what do I need to put in there?

[TuneMaster]

Set B1650 to 8170

[1stGlance]

I don't seem to have that table when I tried to check ? B1650 ?

[Taz]

I don't seem to have that table when I tried to check ? B1650 ?

Answered in your other thread .. odds are you are working with a Gen III controller - no B1650. This is a Gen IV thread.


Regards,
Taz

[PRAY]

Thanks again Taz. You the man.

[PRAY]

Here is a funny. Forgot to set the table and got half way down the street and hit Reduced engine power. Then it hit me. I would have been sucking with out that table Taz. Thanks again.