Error $5 (analog wideband logging)

[rumblebox]

update: i finally got motivated to hook it up again. i disconnected the LC-1(analog), and the scan tool WILL log now. i also found all my orange analog connectors so i can jump A1+ and A1- together and use A2 for the LC-1. it's been a while, so i'm figuring out how to re-configure all my PID's to use the calc.vet with analog. i wish there was a separate calc.vet tutorial strictly for V2 analog users to alleviate confusion.

[joecar]

Pre-Release 06 software/firmware fixes the analog logging problem.


The Calc.VET thread (post #1) shows you how to setup for analog wideband...

for the LC-1, in the calc_pids.txt file, edit CLC-00-110 to read "{GM.EQIVRATIO}*{CALC.AFR_LC11}/14.7".

. . .
II. ANALOG WIDEBAND AND/OR V1 USERS

There are two methods of obtaining analog lambda which are identically the same thing. The first method has the user pre-calculate two constants (i.e. the user pre-calculates this: AFR pid divided by stoich AFR); it evaluates in one step (it evaluates lambda directly in one calculation). The second method evaluates two steps (it evaluates the AFR pid first, then divides it by stoich AFR to obtain lambda).

Method 1:
. . .

Method 2:
Using LC-1 as example:
. . .

You could also reduce those two pids into a single pid:
Define CALC.WO2BEN1 (CLC-00-110) to be {GM.EQIVRATIO}*({CALC.AFR_LC11}/14.7)

. . .

[LSxPwrdZ]

Bringing this back up, I am having trouble logging the AD1-4 in the scan tool. I have verified voltage from my NGK on the V2's display to read the correct voltage however the voltage does not show in the scan tool when logging. The Voltage in the scan tool is showing 66.xx V for all 4 AD inputs.

[joecar]

Bringing this back up, I am having trouble logging the AD1-4 in the scan tool. I have verified voltage from my NGK on the V2's display to read the correct voltage however the voltage does not show in the scan tool when logging. The Voltage in the scan tool is showing 66.xx V for all 4 AD inputs.

Hi James,

Which V2 firmware version do you have in your V2...?


I pm'd Paul.

[LSxPwrdZ]

I will have to check, I did check for updates and it said I had the latest version as of last night. What's weird is it was scanning and working fine a few days ago. The only thing I didn't try is restarting my computer to see if that was the issue.

[LSxPwrdZ]

I'm not getting any error while logging, its just logging 66.xx V for any of the AD1-4. I've confirmed the calibration on the V2 itself and on its display shows the correct voltage when scanning the AD1-4 PIDs.

I am running Firmware 2.07.45 and Boot Block 2.07.05

***EDIT***
Just wanted to give a little update. Seems rebooting all programs and disconnecting all cables and restarting everything solved the issue. It is now logging voltage normally.