Anyone know the build date cut-off for programming?
Thanks,
Anyone know the build date cut-off for programming?
Thanks,
SUBJECT:
No Crank, No Start - Malfunction Indicator Lamp (MIL) With DTC U1601
MODELS:
2009
(DH/D1)
Ram Trucks (2500/3500 Pick Up)
2009
(DC/DM)
Cab Chassis (3500/4500/5500)
NOTE:This bulletin applies to 2009 vehicles equipped with a Cummins 6.7L diesel
engine (Sales code ETJ) built after March 04, 2009 (MDH0304XX)
programmed with bootloader software number 00 06 01 (or later). 2007 and
newer vehicles that have had the ECM replaced with the new bootloader
software will also be effected.
I no longer monitor the forum, please either post your question or create a support ticket.
good thing I saw this where is the build date stamped?
2015 3500HD crew cab long bed, 6" fabtech, slightly tuned, emissions intact.
2005 dmax ccsb, EFI live tuned DSP 5 Full built motor, S471 billet single, More better built trans this time. and lots of other things.
1984 CJ7 powered by a 2000 LS1. 4L60E.
2012 Jetta TDI 6 speed manual, (yes the dirty the bastard haha)
2003 Jetta TDI,
1986 K10 LQ4/4L80E
Les Szmidt
2007 5.9 Dodge Ram
2014 Ram 3500 Aisin tuning Emissions Equipped
EFI Live Cummins BETA Tester
Silver Bullet Tuning
silverbullettuning@gmail.com
www.youtube.com/ljszmidt
http://www.facebook.com/SilverBulletTuninig
Needing to change from the Edge Race and really would like to go with EFI but my MDH is 041712 926AA, ECM # is CM2100A, D/C 04/02/2009. Based off of this I can only assume that I have the locked bootloader.
Anybody on the Western Slope of Colorado that has a 6.7 Smarty I can use real quick? I know I could go with other options but want the tune-ability of the EFI.
Thanks in advance!
John