Calc.VET: correcting MAF and calculating VE (in single log)

[zayne0]

+1 what darcy said...

EXT.WO2LAM1 is stuck at 28.5...

which wideband do you have...?

I have an lm2

[zayne0]

No worries (many people don't even realize screenshots can be taken like this)...

also post screenshot of your scantool map that you applied to tunetool MAF table .

maf map sorry im just now getting back my laptop quit on me, just now got it going again.

[joecar]

No worries, take your time...

In the map properties, on the Data tab set Precision to 3 or 4.

In your map, I see some values creeping too far from 1.0, namely 2.2, 4.0, 2.2, 1.8 and others... your MAF table can't be that far out, post a pic of it.

[joecar]

Post new log and tune files.

[joecar]

I have an lm2

Do both of these:
- LM-2 heater calibration.
- LM-2 free air calibration.

[zayne0]

No worries, take your time...

In the map properties, on the Data tab set Precision to 3 or 4.

In your map, I see some values creeping too far from 1.0, namely 2.2, 4.0, 2.2, 1.8 and others... your MAF table can't be that far out, post a pic of it.

[joecar]

That loooks pretty good.

Post new log and the tune file it came from.

[zayne0]

alright i finally got back around sorry for taking so long. what all am i doing wrong here??

[joecar]

No worries...

post some screenshots of the steps you did...

[zayne0]