Yes, try the rest of the setup procedure, if any step does not work then STOP and post here:
. . .
Note: if you have not yet configured V2 BBx config then continue:
Insert an SD card.
Configure BBx for your PCM or ECM/TCM:
- start V8 Scan & Tune (S&T),
- goto F6: Devices,
- set File System to SD Card,
- save to file Settings.dat,
- click Program,
- click Close,
- goto F5: BBX,
- click Format Config File System (accessed via downarrow next to Program button),
- goto Scan page (see Note below),
- in the blue pane delete pidlists for ECM's other than yours,
- in the blue pane you can add new pidlists for your ECM,
- each pidlist in the blue pane can have a number of pids as shown in the green pane (to which you can add pids from the yellow pane),
- at the bottom of the green pane is a bargraph showing pid usage, do not let this turn red (too many pids selected),
- goto Tune page,
- delete any ECM's other than yours,
- if not already present, add entries for your ECM type(s),
- goto DTC page,
- checkmark the DTC descriptions you want to see,
- save to file Options.txt,
- click Program All (accessed via downarrow next to Program button), wait for it to finish,
- click Close,
- goto F8:Tools,
- in the upper box, browse to your .tun files, and click Convert Now,
- click Close,
- exit V8 S&T.
Note: on the Scan page, the right-hand pane is yellow, the upper-left pane is blue, and the lower-left pane may be green or blue (depending on V8 build version).
2.07.95 is what the firmware says. yes it lights up and works fine. i can still flash controllers and everything else.
Sorry it's been a few days had to go out of town.
Ok I got the analog input on the v2 working.
I will try to finish your instructions on the BBx this weekend.
But the serial is still not working. And if I recall that's why I've always had my wide and on the analog channels
Because I don't think my serial input has ever worked since it was new
But thank you for the help!
Serial checklist: are you using a null modem adapter, did you setup serial wideband in V2 setup, are you plugged into OBD2 port.
Bump for an old thread. Just looking for some help with hooking a LC-2 to my V2. I currently use a LM-1 with the serial cable, but I have a friend with a LC-2. If i use this adapter http://www.sfcable.com/30D1-C1-S.html do I still need to cross wires? If so, which wires? Also, do I have to change any settings in the BBX or V2? Thx
Hi DrkPhx,
No, the null modem adapter already crosses the Rx/Tx wires, so you do not need to modify anything... simply join/connect the LC-2 serial cable to the FSV2 serial cable using the null modem adapter.
You have to configure FSV2 as follows:
- serial com port: wideband
- wideband type: Innovate
more info, see post #3: Setting-up-a-FSV2-from-scratch
You can also configure FSV2 for wideband serial comms by going down the menu tree on the LCD.
Awesome! As usual.. thanks Joecar.