Hey guys,
I've upgraded all of my V2 and software to the latest release and have had to do a bit of work on some cars including my own - put a new wideband in it to check the mixtures after tweaking cracker values a bit.
Anyhoot, I noticed that the car on a cold start was running very "cammy" prior to putting the wideband back in and my suspicions of running lean when cold were right. My A0008 table I command 1.14 multiplier so I should be commanding ~12.8 AFR at cold idle, but the commanded EQR is tapering back to 1.005 and my AFR is around 17:1...
See attached datalog and tune.
20160314 - Open Loop.ctz
LS1B_0425.efi
I have a vague recollection of the car working perfectly when cold so not sure if a bug was introduced at some point. Am I going crazy? A0008 should multiply commanded EQR B3647 on COS3?