ok, I have the switch wired up on pins #1 and #37 in the black connector. I have all 5 limp home tables set to 0mm3 from 1k rpm and up. I also have B0740 min. inj. qty set to 0mm3 from 1k rpm and up. Neither position of the switch will limit fuel.............what gives??
I do NOT want it as a dsp table I want to use a different switch that I can hide. I do not want this for "valet" I want it for added anti-theft.
The first time I tried it, I did not have the switch grounded in #37, I only had it to body ground and B0733 was the only one that would limit fuel and only if B0740 was lowered as well, BUT the switch did nothing, it was stuck in that limiting fuel mode. Now??? I don't get it. Am I missing something?