AEM X-Series OBDII Wideband UEGO AFR Sensor Controller Gauge

[joecar]

i've just ordered 3 of the new aem's for my own cars. so im happy to help test out.

Hi TC,

Have you tried these out using the FSV2 serial comms...?

Have you daisy chained 2 AEM X's into FSV2...?

Did you have to modify the serial cable, or did you use a null modem adapter...?

Thanks.

[joecar]

Whats the difference between V7.5 stream fast and V8 fast can scan modes?

Hi Gelf,

Have you connected your AEM X to FSV2 using serial comms...?

I'm trying to find a few use cases.

Thanks.

[Tre-Cool]

i just make up a cable. there is only 1 tx port on the wideband. so i wire it into the rx port on the v2 unit.

can't daisy chain as the aem unit doesnt have a rx wire. only tx along wiht analog out and can + / -

[joecar]

i just make up a cable. there is only 1 tx port on the wideband. so i wire it into the rx port on the v2 unit.

can't daisy chain as the aem unit doesnt have a rx wire. only tx along wiht analog out and can + / -

Ok, thanks.

So FSV2 can read the AEM X ok...

[Gelf VXR]

Hi Gelf,

Have you connected your AEM X to FSV2 using serial comms...?

I'm trying to find a few use cases.

Thanks.

Sorry no

[Tre-Cool]

yes, but downside is they are being backwards compatible and sending data at the old speed controller speeds, which is noticeable when logging ls1 controllers.

[dr.mike]

Uh.. yeah. That was me

Who do I talk to to find out what I need to do to get the OBDII interface working with EFILive ?
It gives a huge advantage over analog and serial interfaces.

I should be able to tweak the device response to get it working.

Thanks.

[joecar]

Uh.. yeah. That was me

Who do I talk to to find out what I need to do to get the OBDII interface working with EFILive ?
It gives a huge advantage over analog and serial interfaces.

I should be able to tweak the device response to get it working.

Thanks.

On the CAN bus, that would be Blacky (Paul).

[Blacky]

Uh.. yeah. That was me

Who do I talk to to find out what I need to do to get the OBDII interface working with EFILive ?
It gives a huge advantage over analog and serial interfaces.

I should be able to tweak the device response to get it working.

Thanks.

I don't think the EFILive software will allow you to log CAN data from the AEM controller while simultaneously logging data from other CAN controllers.

The V7 EFILive software is hard coded to log data from only a single controller at any one time.

The V8 software will log data from two controllers at a time but only ECM ($7E0) and TCM ($7E2) so you could theoretically set it up as a TCM (assuming the vehicle does not already have a TCM). However, I don't expect the AEM would support the packet-based high-speed logging that EFILive V8 uses. It most likely only supports generic scan mode which V8 does not support/use.

Regards
Paul

[MobileProg]

It's not possible to add support for different headers like $7E1? IIRC the header can be configured to anything. Say "$EF1"

Just throwing an idea out.