I was building a base tune file for my Camaro yesterday when I noticed that the MAF table goes to 8500hz and then skips to 15000. There is no data shown or scale shown in between. The MAF Freq 2 table is complete so I though it was a glitch or something but apparently it is the same with HPT. Is there a way to show this data or re-plot the scale to show it. I dynoed the car stock today and it hit 8400hz. I am going to need the rest of that table to do any mods to this thing. I am assuming that if there isn't a way then I will just add what ever percent to the 15000 slot that I did to the 8500 slot and hope the computer adjusts the curve? I know I can just hit the PE table or the VVE tables I guess but I would like full control over all of the fueling tables.