Is there any support for the E82 ecms yet, i'm not sure if they were in anything pre 2017 or not?
Thanks
Robert
Is there any support for the E82 ecms yet, i'm not sure if they were in anything pre 2017 or not?
Thanks
Robert
04 LB7
2010 LMM
2015 LML
Yes and No, we developed read / cal flash routines for them on a borrowed ECM but they haven't been fully mapped yet (though it might be complete by now I am not sure). Unfortunately too pretty much every 2017 ECM is now on order restriction from GM (such as the E81, E82, E84), we simply cannot buy them. Finally they have new security on all the 2017 ECM's that we have been working on a solution for, more details on that will come shortly.
I no longer monitor the forum, please either post your question or create a support ticket.
Found an issue where when I try to open V7.5 Scan that a data tab is opened over the Beta Warning and I cant close that Data Tab to accept the Beta Warning therefor not being able to use the Scan software.
This may be user error, but I seem to have no luck getting V8 pass-thru logging to connect to an ECM. Auto-detect, OBD status, and BBL all work properly, but when I attempt to record or monitor data the orange LED on the V2 blinks once and an error is shown that it cannot communicate with the controller.
03 6spd
Before asking for help, please read this.
After you get the "No controller detected" save a trace file and attach it to this thread.
To save a trace file, click on the FlashScan icon in the System Tray (on the Windows Task Bar near the clock), select [F8: Trace] and then [Save Trace].
Regards
Paul
Before asking for help, please read this.
Here you are. I had to change the extension to .txt for it to upload.
v8_Scan_NoControllerFound_2.txt
03 6spd
Before asking for help, please read this.