LS1B with 3bar custom os scan tool sae.map pid only reads to 255kpa need read up to 285kpa the same as the boost ve table is there a way to change the sae.map to read 285kpa or o i need a new map so i can log boost past 255kpa need help please
LS1B with 3bar custom os scan tool sae.map pid only reads to 255kpa need read up to 285kpa the same as the boost ve table is there a way to change the sae.map to read 285kpa or o i need a new map so i can log boost past 255kpa need help please
Don't use SAE.MAP, it will only go to 255kPa (not much we can do about that).
Now I don't recall the exact PID to use for the LS1B but look for 'GM.MAPBOOST_DMA', 'GM.MAP2' or 'GM.MAP3' instead if those are valid for LS1B.
I no longer monitor the forum, please either post your question or create a support ticket.
only one that i see but couldnt check value is map sensor MAPBOOST_DMA the more info tab is blank do you think this is it. i did notice that the pcm went above 255kpa when in my run but in my map for ben hit a wall at 255kpa and im running 28# boost
do map voltage and just apply the scaling on a calculated PID if none of that works.
"All that is needed for the triumph of evil is that good men do nothing..."