I am starting to look into using an E80 contoller on the new 1.5L turbo LFV on an engine dyno. I have a controller powered up on a bench and will be trying to communicate with it later today.
One of my concerns is the TCM communication. I'm not entirely sure if I will have to spoof these signals, if I can ignore them and it wont be a problem, or if there is something I can change in the OS/Cal to make this work properly.
I looked through the stickies and some of the posts in this forum, but it looks like most of the controllers that people are using are older, so may not run in to these issues. Has anyone been successful with an E80?
Thanks,