V8 Scan - Calculated Pids

[joecar]

Yes, that is my understanding...


but the following won't define BEN's for all your widebands... it selects whichever of the mentioned pids is available, and from it it calculates this particular BEN.

[WO2CAN.BEN_1]
0=|-- WO2CAN.BEN_1
1=|return pid("WO2S11,WO2S12,WO2S21,WO2S22")/pid("EQ_RAT")

I'm not sure, but see my corrections (based on your definitions above) below:
( and further corrections to correct my omission )

[WO2CAN]
CANBEN_1="Base Efficiency Numerator 1 - Canbus",factor,3
CANBEN_2="Base Efficiency Numerator 2 - Canbus",factor,3
CANBEN_1_E40="Base Efficiency Numerator 1 E40 - Canbus",factor,3
CANBEN_2_E40="Base Efficiency Numerator 2 E40 - Canbus",factor,3

[WO2CAN.CANBEN_1]
0=|-- WO2CAN.CANBEN_1
1=|return pid("WO2S11")/pid("EQ_RAT")

[WO2CAN.CANBEN_2]
0=|-- WO2CAN.CANBEN_2
1=|return pid("WO2S12")/pid("EQ_RAT")

[WO2CAN.CANBEN_1_E40]
0=|-- WO2CAN.CANBEN_1_40
1=|return pid("WO2S11")*pid("EQ_RAT")

[WO2CAN.CANBEN_2_E40]
0=|-- WO2CAN.CANBEN_2_E40
1=|return pid("WO2S12")*pid("EQ_RAT")

Too bad about the E40 EQR being inverted.