Get up to date with old license

[ScarabEpic22]

Back in the day around circa 2010, I recall we had to down load the LS1-A Stream in order to tune the LS1-A Free. I no longer see that option available for download.

My personal V2 has that option enabled.

How ever I purchased a 2nd unit used and the option was never activated...

Both are the older black V2 units, Not sure if its just automatically enabled on the new Blue units or not. Be curious to know if any one knows on that.

Send an email to [email protected], I believe this is still a free enhancement so they just have to generate an auth code for you.

I need to clarify some info I posted earlier in this thread.

I was under the impression that the V1 Commercial Scan and Tune came with 5 licenses. I think that is wrong and it is only 4 licenses - all of which I currently have unused because I have only used the V1 cable to scan and tune my 1998 Camaro.

So if I was to upgrade to V2 I would still have 6 unused licenses with one of those where I could scan and tune my 2012 GS Corvette leaving a total of 5 unused licenses on either V1 or V2 dependent upon how I upgraded from V1 to V2.

Correct, 4 licenses would be on your V1 originally plus free LS1A tuning. When you purchase a V2 upgrade, it will come with 2 VIN licenses + free LS1A stream. When you go through the upgrade process (required to activate your V2), you have the option to keep OR move the existing unused 4 PCM licenses AND copy the used PCM licenses (not applicable as you don't have any used licenses) from your V1 -> V2. This is a ONE TIME deal, if you don't copy/move them, you can't do it later. You can only move licenses from V1 -> V2, not from V2 -> V1. You do not get to keep say 2 PCM licenses on your V1 AND move them to your V2 as VIN licenses. Remember, once you upgrade your V1, you cannot purchase additional V1 PCM licenses so if you wanted to use the cable in the future, you MUST leave PCM licensees on it during the upgrade.

V1: 4 PCM license available, 0 used.
V2: 2 VIN licenses available, 0 used.

After V1 -> V2 migration:
V1: 0-4 PCM licenses available, 0 used.
V2: 6-2 (2 existing + # moved from V1) VIN licenses available, 0 used.

Personally, since you have a single LS1A vehicle, I would move all to your V2 as all vehicles since then you have 6 VIN licenses applicable for all supported vehicles vs licenses you can only use on controllers up to 2005. But, it's up to you!