how do i use this spread sheet i understand that you copy and paste the ben's in do i start with copy and pasting the b0101 first and then paste over the top sorry if i missed somthing thanks in advanced
how do i use this spread sheet i understand that you copy and paste the ben's in do i start with copy and pasting the b0101 first and then paste over the top sorry if i missed somthing thanks in advanced
You paste your BENs in the top table, then copy the bottom table and paste-multiply into your VE table.
no worries, feel free to post questions/comments/tol (thinking out loud).
When i did this , it made lots of spikes In my ve table. Suggestions?
2000 NBM trans am.
427 Dart ship block,Lme ported Ls7 heads 12.5 compression
246/262 .730/.712 112+4 low lash solid roller
Rmvb 4l80 with transbrake, 8" FTI converter
12 bolt Moser rear end with 4.10 gears
Ok, maybe then avoid the interpolation spreadsheet;
instead, paste-multiply the BEN into the VE table, and then manually adjust the surrounding un-hit cells to match/flow with the hit cells.
I was just trying to figure out how to use this. Looks like a great idea
2000 NBM trans am.
427 Dart ship block,Lme ported Ls7 heads 12.5 compression
246/262 .730/.712 112+4 low lash solid roller
Rmvb 4l80 with transbrake, 8" FTI converter
12 bolt Moser rear end with 4.10 gears
It works in certain situations. Do it as joecar says.
"All that is needed for the triumph of evil is that good men do nothing..."