Anyone have a pinout to make a bench harness for a 99-02 Cavalier with P08?
Thanks
Anyone have a pinout to make a bench harness for a 99-02 Cavalier with P08?
Thanks
Pretty sure it is the same as the LS1B.
I no longer monitor the forum, please either post your question or create a support ticket.
Yes it has less pins but the important ones are in the same spot.
The LS1B bench harness I have runs all those PCM's you've listed there, V6-P04, Northstar-P06, they are all the same pinout for bench connections (and of course E54 - LB7).
I just put a P08 on my LS1B bench harness and it works fine.
Blue 60 = Ground
Blue 20 = 12V Unswitched (Batt)
Blue 19 = 12V Switched
Blue 58 = VPW Serial Data
I no longer monitor the forum, please either post your question or create a support ticket.
Interesting... I will try again and count the pins on the LS1B Connector instead of the ecm.
Oddly if I connect a V6 Buick to my LS1B harness it will blow fuses immediately. (Using a older Kent Moore bench harness)
Connecting to this Cavalier one and it back feeds power to the key on circuit.
EFI Connection sells a seperate harness for all these for this reason
My harness had to many wires. I simplified it down and works. You was right as normal... Thanks for the help.
I no longer monitor the forum, please either post your question or create a support ticket.
Probably a project that should never have happened to be honest, horrible PCM that one.
I no longer monitor the forum, please either post your question or create a support ticket.