LS1B 1bar SD COS

[hrspwr]

Why are you choosing to not run a MAF sensor?

The testing that I have done, shows that the MAF is starting to become a restriction. With MAF, the MAP is around 92-94kpa through a pull and without it its consistently around 97. The log attached earlier still has the MAF in place, only disconnected.

[joecar]

The testing that I have done, shows that the MAF is starting to become a restriction. With MAF, the MAP is around 92-94kpa through a pull and without it its consistently around 97. The log attached earlier still has the MAF in place, only disconnected.

Post a pic of your MAF plumbing...?

What TQ and HP are you developing...?