connecting 5v pressure sensor directly to v2

[RADustin]

not sure if this forum is active but I have a general question..

If I wanted to connect a 0-5V pressure sensor directly to the V2, does the V2 source the 5 volt power to the sensor? or can I just only run the signal back to the V2 and I need to find my own 5V source?

Also generally looking for more info on connecting directly to these ports on the V2, like pin outs and such.

Thanks

[nonnieselman]

Found this on Page 104 on the EFILiveV75Scan.pdf.

You will need a 5 Volt source from the PCM to power your sensor.

[joecar]

FSV2 does not provide 5V output, you have to provide your own.

FSV2 only provides signal input and signal ground.