To use it, log commanded AFR and WBO2 AFR in their own maps (vs. MAP pressure and RPM like the VE table is setup) instead of BEN's. Paste the averages in the first two boxes on the VE WBO2 tab for your application. Then, go back and copy the number of cell hits (n) and paste them into the 3rd box. As attached, the N Factor is set to 100 and 50. If you have less than 50 cell hits, the data will be ignored. If you have more than 50 but less than 100, the low N Factor correction will be used. If you have more than 100, the high N Factor correction will be used. So now, you can apply any percentage of a correct that you would like.
Hold your mouse over the yellow headers with a red triangle in the the upper right corner for further instructions.
Reply With Quote