may do the job.
Measurement Specialties has 1, part No: MSP-600-100.
It's available from Digikey. Price I just found was $95.00USD.
Saw this info on another board, [Gary Z, Ls1tech posted it]. I am going to try to make 1 work...
may do the job.
Measurement Specialties has 1, part No: MSP-600-100.
It's available from Digikey. Price I just found was $95.00USD.
Saw this info on another board, [Gary Z, Ls1tech posted it]. I am going to try to make 1 work...
Chuck L.
CODY Motorsports
Fuel Injector Service
Madison, GA.
706-342-3152
770-265-5144 [C]
The hot ticket is to watch ebay. I bought a few MIL spec versions of that for $10 or $15 each or so a few years back.
Ira
[QUOTE=Beer99C5]Waiting on the harness...
could you tell me the wire pin outs for this connector.
i am making my own harness for this sensor.
thanks
Looking at it as pictured
Black is Left, Grey is Right
_____Purple Single______
From what I can tell from one of my Pics
(out of country, so not car is not available to me)
1999 C5 A-4 Convertible
1 of 245 Nassua Blue 99 Vert's, Blackwing, LS6 Intake, 42 # Injectors, Two Stage Nitrous System- Dry and a Wet Plate, EFI Live Scan/Tune V2, 1999 PCM with 2002 COS 5 OS Custom Nitrous Panel.
Maine USA
with the clip facing up?Originally Posted by Beer99C5
are there numbers on the connector?
i don`t want to screw the sender up it was $90
To be sure go to the autometer site and submit the question on their form, they are good about getting back to ya, usually within a day.
1999 C5 A-4 Convertible
1 of 245 Nassua Blue 99 Vert's, Blackwing, LS6 Intake, 42 # Injectors, Two Stage Nitrous System- Dry and a Wet Plate, EFI Live Scan/Tune V2, 1999 PCM with 2002 COS 5 OS Custom Nitrous Panel.
Maine USA
OK I got a question - would it be possible to use a 0-80 lb oil pressure sending unit? Hook it up to one of the 12V inputs on the V2??? I can't see why not, I mean they both measure pressure of a petroleum product so I would think safety wouldn't be an issue... If so it sure would be nice to get a $10 sending unit to do the same job. Feedback anyone?
Mr. P.
Originally Posted by Mr. P.
The data needs to be 0-5V, that is what is used to get the pressure. The 12 Volt inputs are used for relay's indication and have a value of 0 and 1, 0 if there is no power to the relay, and 1 if the relay has power.
1999 C5 A-4 Convertible
1 of 245 Nassua Blue 99 Vert's, Blackwing, LS6 Intake, 42 # Injectors, Two Stage Nitrous System- Dry and a Wet Plate, EFI Live Scan/Tune V2, 1999 PCM with 2002 COS 5 OS Custom Nitrous Panel.
Maine USA
Thank you, did not realize they were switched inputs.Originally Posted by Beer99C5
Mr. P.