BB Logging beta update: May 06, 2008

[02Z06]

I would be interested to know your results if you removed the AFR_B| and just had ECM,AFRATIO_M.

Regards
Paul

I will edit the config. file and give that a try.

[02Z06]

I would be interested to know your results if you removed the AFR_B| and just had ECM,AFRATIO_M.

Regards
Paul

I just re-configured the V2 with the AFRATIO_M Pid and it still says de-select this Pid.

[XLR8NSS]

Are you logging GM.ETCTP or GM.TP? For the E38's here is Aus, you must log using GM.ETCTP for it to actually indicate throttle %. GM.TP will give a reading, but it will be a % of the 5v signal for the fly by wire system. GM.TP will max out at 80%

Simon.

I was having the same problem logging GM.TP. I changed to GM.ETCTP and now see the correct TPS reading on my E38.

Thanks for the tip.

[TFZ_Z06]

Just wanted to report in. I have upgraded FlashScanV2 and tested a PCM READ and SCANNING. Everything seems to work flawless.

[dfe1]

Are you logging GM.ETCTP or GM.TP? For the E38's here is Aus, you must log using GM.ETCTP for it to actually indicate throttle %. GM.TP will give a reading, but it will be a % of the 5v signal for the fly by wire system. GM.TP will max out at 80%

Simon.

Thanks. That's probably the problem. I'll try it next time I data log an E38.

[TFZ_Z06]

Well, guess I was wrong. The scanner will not log O2 sensor voltages.
Any ideas?

[swingtan]

Well, guess I was wrong. The scanner will not log O2 sensor voltages.
Any ideas?

Try reading the PID description files in

EFILive\V8\EFILive_Hapi\Pid Descriptions

These files list all the supported PIDs and their descriptions for each controller. All you need to do is select the required PID's and enter them correctly into the options.ini file, then copy the options.ini file to the V2 unit.

For example, to log O2 sensor voltages in the E38, add these lines...

ECM, O2S11V
ECM, O2S21V

Remember to watch your channel count when adding additional PIDs.

Simon.

[thunder550]

Try deleting that file.
Regards
Paul

Deleted it and still getting the same error.

[Cougar281]

Not sure if anyone has mentioned it, but if I clear DTCs on my LLY, I get an Error $0281 again.

[joecar]

Well, guess I was wrong. The scanner will not log O2 sensor voltages.
Any ideas?

Is this on your 2002 LS1/LS6...?

Did you select the LS1B_x pids...?

In your Option.ini file, for your selected pid list, does the channel count add up to 24 or less...?

Does the V2 display voltages for H02Snn...?

In the scantool, when viewing those BBL logs, have you entered your VIN and OS ID...?

Save your Options.in file somewhere safe, and try my options.ini...

Cheers
Joe